ExFinity
Mangaka Apprentice
2
MONTHS
2 2 MONTHS OF SERVICE
LEVEL 1
400 XP
Loading…
puu.sh
Loading…
puu.sh
I just insert the picture randomly, the picture below is not related to this guide. The guide is from other place:
1. Download and install JumpStart, WinPcap, and Dumpper
2. Open Dumpper, in the 'Networks' tab, select the network adapter you wish to use. Hit the 'Scan' button now.
3. After it completes the scan, go over to the 'Wps' tab. In the area that says 'Connect using JumpStart', hit 'Browse' to select the location of where you installed JumpStart in the previous set-up steps. (By default, it installs in C:\Program Files (x86)\Jumpstart. Don't open it, just select the 'Jumpstart' folder and click 'OK')
Loading…
puu.sh
5. Hit the 'Scan' button.
6. Select the network you wish to penetrate. Remember the 'Pin' corresponding to your network in the scan results, this will be needed for later.
7. In the previous area 'Connect using Jumpstart', hit the 'Start JumpStart' button.
Loading…
puu.sh
9. Under 'Which setup method do you want to use?', select "Enter the PIN from my access point" and enter the PIN next to your network in the scan section back in the previous scan results.
10. Finally, select the targeted network from before and hit 'Next'.
11. Now you're happily connected to that WiFi network you just penetrated. Do you want to see the password so you can get on from other devices without doing this process? Sure! Follow these simple steps:
12. Open the menu where you join WiFi networks/view the network you're connected to.
13. Right click on the network you just joined and hit 'Properties'
14. Under the 'Security' tab, you can see the password, but it's just dots. Check the 'Show characters' box under it.
15. The password will then reveal itself.
Download:
Please give a like
or you *will* be considered a leecher.
You must upgrade your account or reply in the thread to view hidden text.